How to Replace Wiper Blades and When They Need Changing
The first proper downpour of autumn arrives, you flick the wipers on, and instead of a clear screen you get streaks, judder and a smear right across your line of sight.

The first proper downpour of autumn arrives, you flick the wipers on, and instead of a clear screen you get streaks, judder and a smear right across your line of sight. Learning to replace wiper blades yourself takes about five minutes per side, costs a fraction of a garage fitting, and needs no tools on most cars.
I have changed blades on everything from small hatchbacks to vans, and the job is genuinely simple once you know which connector your car uses. Here is how to tell when blades are worn, how to buy the right size, and how to fit them without cracking the windscreen.
Signs it is time to replace wiper blades
Rubber breaks down with sun, frost and road grime, so most blades need changing every 6 to 12 months even if they look fine. Watch for these:
- Streaking. Thin lines of water left behind after each pass usually mean the rubber edge has hardened or worn.
- Smearing. A greasy film across the glass can be dirty blades, but if cleaning does not fix it, the edge is gone.
- Chattering or juddering. The blade skips across the glass instead of gliding. Hardened rubber is the usual cause.
- Missed patches. A section of glass that never clears points to a bent frame or a split in the rubber.
- Visible damage. Lift the blade and run a finger along the edge. Cracks, nicks or a rounded edge all mean replacement.
Worn blades are more than an annoyance. In heavy rain at night, a smeared screen scatters oncoming headlights and cuts what you can see. Clear vision is part of the same safety check as checking tyre tread depth before winter.
How to find the right wiper blade size
Most cars use different lengths for the driver and passenger sides, and many have a separate rear blade. Getting this wrong is the most common reason people return blades.
- Check the handbook. Blade lengths are often listed in the specifications section.
- Measure the old blades. Measure the rubber end to end in millimetres or inches. Typical front sizes range from 350 mm to 700 mm.
- Use a parts shop lookup. Enter your registration or make, model and year, and it will list the correct lengths and connector type.
Also note the connector. The hook type is the most common. Many newer cars use a pinch tab, side pin or push button fitting. Most aftermarket blades come with adapters, but it saves time to know which one you need.
Blade types compared
| Type | Typical price per blade | Pros | Cons |
|---|---|---|---|
| Conventional frame | 5 to 12 GBP | Cheap, widely available | Can lift at speed, frame can ice up |
| Flat or beam blade | 12 to 25 GBP | Even pressure, quieter, better in winter | Costs more |
| Hybrid | 15 to 25 GBP | Beam blade feel with a protective cover | Fit can be specific to certain cars |
If your car came with flat blades from the factory, stick with flat blades. Swapping to cheap framed blades often brings back wind noise and lifting on the motorway.
How to replace wiper blades step by step
This covers the common hook fitting. Other connectors follow the same idea with a different release.
- Put the wipers in service position if needed. On many modern cars, the wipers park under the bonnet edge. Turn the ignition off, then within a few seconds hold the wiper stalk down to raise them. Check the handbook for your car.
- Lay a towel on the windscreen. If the bare metal arm snaps back onto the glass, it can chip or crack it. A folded towel takes the hit.
- Lift the arm away from the glass. It should stay upright on its own.
- Release the old blade. Turn the blade so it sits at right angles to the arm. Press the small release tab, then slide the blade down and off the hook.
- Fit the new blade. Fit the correct adapter if one is needed. Slide the hook into the new blade's connector until it clicks.
- Check it is secure. Tug gently. It should not move.
- Lower the arm carefully onto the glass and repeat on the other side.
- Return the wipers to park position by switching the ignition on and running them once with washer fluid.
The whole job takes 5 to 10 minutes for a pair. Do the rear blade at the same time if it is streaking.
Why you should not buy the cheapest pair every time
A lot of drivers buy the cheapest pack at the supermarket on the theory that all rubber is the same. I disagree. Budget framed blades often lose their edge within three or four months, especially after a summer of hot sun. Over a year you can end up fitting two or three cheap pairs where one decent flat blade pair would have lasted.
Spending 25 to 40 GBP on a good pair, then changing them once a year before winter, is cheaper per month and gives a clearer screen. The exception is an older car with framed arms that do not suit flat blades. There, a mid-priced framed blade is fine.
If the new blades still streak
Fresh blades should clear the screen perfectly from the first wipe. If they do not, the problem is usually the glass, not the rubber. Wax, road film and old screenwash residue leave a coating that new blades smear around. Clean the windscreen thoroughly with a glass cleaner and a microfibre cloth, then wipe the rubber edges with a little screenwash.
If streaking continues, check the arm. A tired spring presses the blade too lightly, so it skims over the water. Lift the arm a few centimetres and let it go gently. It should press back firmly. A weak arm needs replacing, which is a garage job on most cars.
Making new blades last longer
- Never run them on a dry or frozen screen. Ice tears the rubber edge. Defrost first.
- Wipe the rubber monthly with a cloth and a little washer fluid or diluted screenwash to remove grit.
- Keep the screen clean. Tree sap and bird mess drag on the edge. A clay bar treatment, done as part of the routine in our guide to waxing a car by hand, leaves the glass very smooth.
- Use proper screenwash rated for winter temperatures, not plain water, which freezes and does little against grime.
- Lift the arms in heavy frost if you park outside, so the blades do not freeze to the glass.
Pair this with a quick look at the rest of your fluids. Our guide to checking your coolant level takes another five minutes on the same driveway.
Frequently asked questions
How often should you replace wiper blades?
Every 6 to 12 months for most drivers. Cars parked outside in strong sun or hard frost may need new blades closer to every six months. Replace them sooner if you see streaks, smearing or juddering that cleaning does not fix.
Can I replace wiper blades myself?
Yes. On most cars it needs no tools and takes about five minutes per blade. Check the size and connector type first, and lay a towel on the glass so the arm cannot snap back onto the windscreen.
Are flat wiper blades better than framed ones?
Flat blades usually give more even pressure, make less noise and cope better with ice and snow. They cost more, but often last longer. If your car originally came with framed blades, a good framed replacement can also work well.
More in Car Care
Car Care
How to Remove Tree Sap and Bird Droppings From Car Paint
I parked under a lime tree in July for four days while I was away on a bike trip.
Car Care
How to Stop Your Windscreen Fogging Up on the Inside
Every November the same thing happens in my neighbour's driveway.
Car Care
How to Clean Alloy Wheels Without Damaging the Finish
I ruined a set of wheels learning this. Diamond cut faces on a hatchback I had owned for four months, and a bottle of...