How to Change Motorcycle Oil at Home Step by Step
A dealer oil service can cost 80 to 150 for a job that uses about 40 worth of oil and a filter. If your bike is out of warranty, or the warranty allows owner servicing with records, you can change motorcycle oil at home in under an hour...

A dealer oil service can cost 80 to 150 for a job that uses about 40 worth of oil and a filter. If your bike is out of warranty, or the warranty allows owner servicing with records, you can change motorcycle oil at home in under an hour with a few basic tools, and you will know it was done properly.
I have done this on everything from a 125 commuter to a big adventure bike, and the steps barely change. What does change is the oil spec and the torque figures, so keep your owner's manual open beside you. Here is the full process, plus the mistakes I see most often.
When to change motorcycle oil
Follow the interval in your manual first. Most modern bikes call for an oil and filter change every 4,000 to 6,000 miles, or once a year, whichever comes sooner. Older air cooled bikes and many small capacity singles want it more often, sometimes every 2,000 to 3,000 miles.
Change it sooner if you mostly do short trips under 5 miles, ride in very hot weather, or the oil in the sight glass looks dark and gritty. Also change it before laying the bike up for the cold months. Old oil contains acids from combustion that slowly attack engine parts while the bike sits. Our guide to storing a motorcycle for winter explains why that timing matters.
What you need
- The right oil, usually 2.5 to 4 litres. Check the exact capacity with a filter change in the manual.
- A new oil filter for your model.
- A new drain plug crush washer. They cost pennies and stop slow leaks.
- A socket or ring spanner for the drain plug, typically 14 mm to 17 mm.
- An oil filter wrench that fits your filter.
- A drain pan holding at least 5 litres.
- A funnel, nitrile gloves, rags and a torque wrench.
- A paddock stand or centre stand, so the bike is upright.
Choosing the right oil
Two numbers matter on the bottle. The viscosity, such as 10W-40, must match your manual. The second is the JASO rating. Most motorcycles have a wet clutch that runs in the engine oil, so they need oil rated JASO MA or MA2. Car oils labelled "energy conserving" contain friction modifiers that can make a wet clutch slip.
Scooters with a dry belt drive often call for JASO MB instead. When in doubt, the manual wins.
How to change motorcycle oil step by step
1. Warm the engine
Run the engine for 3 to 5 minutes, or ride around the block. Warm oil flows faster and carries more dirt out with it. Do not drain it straight after a long ride, though. The exhaust and oil can be hot enough to burn.
2. Get the bike upright and stable
Put it on a paddock or centre stand on level ground. Slide the drain pan under the drain plug, which is usually at the lowest point of the engine casing. Loosen the oil filler cap on top of the engine so air can get in and the oil drains smoothly.
3. Remove the drain plug
Crack the plug loose with the spanner, then unscrew the last few turns by hand while pushing it inward. Pull it away quickly once the threads release. Let the oil drain for at least 10 minutes. Wipe the plug and check its magnetic tip, if it has one. A light grey paste is normal. Chunks or flakes of metal are not, and need a mechanic's look.
4. Change the filter
Move the pan under the filter and unscrew it with the filter wrench. Expect another 100 to 200 ml of oil. Wipe the mounting face clean. Smear a little fresh oil on the rubber seal of the new filter, screw it on by hand until the seal touches, then turn it a further three quarters of a turn. Check the filter box for the exact figure.
5. Refit the drain plug
Fit a new crush washer and screw the plug in by hand. Tighten it with a torque wrench to the figure in your manual, often between 20 and 30 Nm. Aluminium engine cases strip easily, and an overtightened plug is one of the most expensive home servicing mistakes.
6. Refill and check
Pour in about 90 percent of the stated capacity through a funnel. Refit the cap and run the engine for one minute, then switch off and wait 2 to 3 minutes. With the bike upright, check the sight glass or dipstick. Top up a little at a time until the level sits between the marks. Overfilling is as bad as underfilling.
7. Check for leaks and clean up
Look at the drain plug and filter for drips after a short ride. Pour the old oil into its empty bottles and take it to a recycling centre. Most accept engine oil free of charge. Never pour it down a drain.
The expensive oil myth
Riders often say you should always buy the most expensive full synthetic oil you can find. I disagree. A premium synthetic does resist heat breakdown better, which matters on a high revving sports bike ridden hard. But for most commuters and tourers, a mid priced oil with the right viscosity and a JASO MA2 rating does the job perfectly, provided you change it on time.
Fresh oil at the correct interval protects an engine far better than expensive oil left in for twice as long. Spend the difference on a quality filter and a torque wrench instead.
Common mistakes to avoid
| Mistake | What happens | How to avoid it |
|---|---|---|
| Reusing the crush washer | Slow leak from the drain plug | Fit a new one every time |
| Overtightening the plug | Stripped threads in the casing | Use a torque wrench |
| Using car oil | Clutch slip under power | Buy JASO MA or MA2 |
| Checking level on the side stand | Overfilling | Check with the bike upright |
| Forgetting the old filter seal | Double seal, oil sprays out | Make sure the old seal came off |
Write the date and mileage in a notebook or in the service book. It keeps your records straight for resale and reminds you when the next change is due. While the bike is on the stand, it is a good moment to check chain tension and lube too.
Frequently asked questions
How often should you change motorcycle oil?
Most modern motorcycles need an oil change every 4,000 to 6,000 miles or once a year. Older bikes and small engines may need it every 2,000 to 3,000 miles. Your owner's manual gives the exact interval for your model.
Can I use car oil in my motorcycle?
It is not recommended for bikes with a wet clutch. Many car oils contain friction modifiers that cause the clutch to slip. Look for a JASO MA or MA2 rating on the bottle instead.
Do I need to change the oil filter every time?
Most manufacturers recommend a new filter with every oil change, and it is cheap insurance. Some older manuals allow a filter change every second service. If you are unsure, change it every time.
More in Motorcycles
Motorcycles
How to Check Motorcycle Brake Pads and Brake Fluid
A commuter bike came into our workshop years ago with a noise the owner described as a seagull.
Motorcycles
How to Make a Tight U-Turn on a Motorcycle Safely
I dropped a loaded tourer in a lane outside Machynlleth in front of a farmer who was patient enough not to laugh.
Motorcycles
Motorcycle Pre-Ride Check: A Five Minute Daily Routine
The rider who loses a rear brake light on a dark ring road rarely notices until a van fills the mirrors.